中文

ENGLISH

 
News
5-axis CNC machining requirements for aviation parts
Release time:2020-10-28

Aviation parts are products with high precision and processing difficulty. Half of them are produced by 5-axis CNC machining. First, the materials for aerospace parts must be good because they involve many factors such as pressure and temperature in the air. It is necessary to consider that there must be no problems when using it. Therefore, it is necessary to use suitable materials for processing before processing. Before the processing, the material should be inspected without the appearance of fine holes and some undesirable phenomena to ensure the quality of the material.

5-axis-CNC-machining

 

Care must be taken during processing to pay attention to the details, because such parts can not be welded, if the welding may cause problems in the process of application, so be sure to pay attention to details during processing to avoid abnormalities in processing can not be welded. When you get on or off the machine, you should also pay attention to the bumps. Make sure that the workpiece is harmless. Care must be taken when vowin.cn/en/News/news1251.html' target='_blank'>machining tolerances are met. Make sure that the accuracy is accurate and that there is no problem when using it.

 

Machining on five axes can reduce the number of clamping of aeronautical parts and improve the efficiency of machining. If there are more turning, it can reduce the error of each surface on the five axes and only need to be clamped on the five axes. The processing of five faces can be completed in one operation. In terms of efficiency and cost savings, it is more advantageous. In the five-axis machining, it is necessary to pay attention to the fact that there is no source near the machine tool, otherwise it may interfere with the stability during the five-axis machining.

We have  comprehensive professional knowledge, good cooperation and communication skills. Professional production of hand board, Demaggio 5 axis finishing, 4-axis cnc small batch finishing, vacuum complex molding, sheet metal processing and other services.

Previous:It is a casting process for elastomers using a vacuum to draw the liquid material into the mold. The process starts by placing two pieces silicon mold in a vacuum chamber . The raw material is mixed and degassed and then poured into the mold .Firstly,
Next:5-axis machining service processing

Design

Prototype

Low Volume Production

Mold

Production

Contact